Logging results

 Google sheets

https://docs.google.com/spreadsheets/d/19-Kt2w943iOmKBSE3WLt_KgMJZE2o_svyXJnUlgYrjw/edit?usp=sharing

Recording time to drop from 4v to 3v (since that covers most of the time and is simple)

Comments

Post a Comment

Popular posts from this blog

Introducing Easynow - an ESPHome component to make sensor proxying via ESPNow easy in ESPHome.

Image
I think my ESPNow proxy components are now working well enough to release. https://gitlab.com/ripnetuk-public/espnow/ripnetuk-esphome-easynow It can be used in ESPHome simply by adding YAML, since ESPHome can pull external components direct from a Git repo - well done ESPHome :) Initial tests are good - using the same device that I was getting roughly 8 hours out of (from a discarded [popular device] - 700maH),  On previous measurements, I was timing the main part of the discharge curve, from 4v down to 3v, and was getting approx. 8-9h of runtime. This was taking a reading every 60s and passing to HomeAssistant via the regular API (ie, using the built in ESPHome stuff) BEFORE Easynow So it was taking between ~18:00 to ~02:45 to discharge from 4v to 3v. Thats about 8/9 hours. WITH Easynow Well, this is awkward. Its worked so well that after 8 hours, it havent even yet got down to the 4v ive been testing at: yet its still successfully reading the temperature every 30s: So far, id cal...
Read more

SSD Upgrade on Lenovo Legion Go - Part 2 - Restore backup

Image
 TL;DR; - It worked perfectly as expected. 0. Prerequisites Same as part 1 2. Go into BIOS and disable internal battery (to disconnect the internal battery until external power is applied). Also disable secure boot. 2. Replace the SSD in the device. I bought one of these: https://www.amazon.co.uk/dp/B0C5YS3QY4?psc=1&ref=ppx_yo2ov_dt_b_product_details and the adaptor to make it long enough for the Legion Go https://www.amazon.co.uk/dp/B0BLJNGGVD?psc=1&ref=ppx_yo2ov_dt_b_product_details The hardware swap is well documented elsewhere. The hardest part was removing the foil from the old drive. 3. Insert the USB stick prepared earlier with Veeam and activate the boot menu (vol+ while power on, select boot menu. Also attach the large external drive with the backup image from before. 4. Boot from the USB stick prepared with Veeam 5. Wait for quite a while while it boots... 6. Pick bare metal recovery 7. Backup location - local storage... next... 7. Restore mode - entire computer (...
Read more