Good guide cross flash crossfLASH h730 h310 IT mode dell mini card

Guide with downloadeable sort it iso

Comments

Post a Comment

Popular posts from this blog

Emergency safe mode on ESPHome and ESP32 (re-using EN button on GPIO0)

 The GPIO0 'enable' button is usually only used at boot to put the device into flash mode. After it has booted, we have a spare physical button on most dev boards. We can use this to flag that ESPHome needs to go into safe mode (ie, not run any components other than wifi and ota). We need to add an ID to the ota component: ota :   id : theota   password : "(readcted)" Then add the following YAML globals :   - id : press_ms     type : int binary_sensor :   - platform : gpio     id : failsafe     pin :       number : 0       mode :         input : true         pullup : true       inverted : true     on_press :       then :         lambda : !lambda |-           id(press_ms) = millis();     on_release :       then :         lambda : !lambd...
Read more

Introducing Easynow - an ESPHome component to make sensor proxying via ESPNow easy in ESPHome.

Image
I think my ESPNow proxy components are now working well enough to release. https://gitlab.com/ripnetuk-public/espnow/ripnetuk-esphome-easynow It can be used in ESPHome simply by adding YAML, since ESPHome can pull external components direct from a Git repo - well done ESPHome :) Initial tests are good - using the same device that I was getting roughly 8 hours out of (from a discarded [popular device] - 700maH),  On previous measurements, I was timing the main part of the discharge curve, from 4v down to 3v, and was getting approx. 8-9h of runtime. This was taking a reading every 60s and passing to HomeAssistant via the regular API (ie, using the built in ESPHome stuff) BEFORE Easynow So it was taking between ~18:00 to ~02:45 to discharge from 4v to 3v. Thats about 8/9 hours. WITH Easynow Well, this is awkward. Its worked so well that after 8 hours, it havent even yet got down to the 4v ive been testing at: yet its still successfully reading the temperature every 30s: So far, id cal...
Read more

SSD Upgrade on Lenovo Legion Go - Part 1 - Backup the original drive using Veeam

Image
0. Prerequisites a) An adapter to allow you to plug USB devices into the Legion Go. I used this from Amazon: https://www.amazon.co.uk/dp/B09H44S96B?psc=1&ref=ppx_yo2ov_dt_b_product_details You might want to do some research on this - its doubled in price since I bought it last week, and its very slow (25Mb/s to the external SSD which can do 500Mb/s, but it might be the cage) If you buy this adaptor, make sure you plug the drive into the 1 out of the 4 USB ports that supports USB 3 :) b) An external drive big enough to hold the Legion Go SSD (in my case, 512Gb). I use a Samsung SATA SSD in a USB3 cage, since that is what I have. c) A Windows 11 iso. This can be downloaded from Microsoft (this is used to create the recovery media) The windows ISO is only needed if the computer doesn't have a recovery partition, which the Legion Go DOES, so this is not needed here. 1. Plug in a blank USB stick for the recovery media 2. Download Standalone Veeam Agent for Microsoft Windows here: ht...
Read more